《電子技術應用》
您所在的位置:首頁 > 模擬設計 > 解決方案 > SupertexHV7355八路150V1.5A超聲波脈沖器解決方案

SupertexHV7355八路150V1.5A超聲波脈沖器解決方案

2012-06-18
作者:Supertex公司

Supertex公司的HV7355是八路單極高壓高速超聲波脈沖發生器,輸出電壓0V-150V,源和沉電流為±1.5A,連續波模式±300mA,高達18MHz工作頻率,2.5V-3.3V CMOS邏輯接口,主要用在手提超聲波圖像儀,壓電傳感器驅動器,NDT超聲波發送器和脈沖波形發生器.本文介紹了HV7355主要特性, 典型應用電路以及150V/1.5A單極超聲波脈沖器演示板HV7355DB1主要特性, 方框圖和電路圖.

Eight Channel, High Speed, Unipolar, Ultrasound Pulser 1.5A 150V

The Supertex HV7355 is an eight-channel, unipolar, high voltage, high-speed pulse generator. It is designed for medical ultrasound applications. This high voltage and high speed integrated circuit can also be used for other piezoelectric, capacitive or MEMS sensors in ultrasonic nondestructive detection and sonar ranger applications.

The HV7355 consists of a controller logic interface circuit, level translators, MOSFET gate drivers and high current P-channel and N-channel MOSFETs as the output stage for each channel.

The output stages of each channel are designed to provide peak output currents over ±1.5A for pulsing, when MC = 1, with up to 150V swings. When MC = 0, all the output stages drop the peak current to ±500mA for low-voltage CW mode operation to save power. This direct coupling topology of the gate driver not only saves one high voltage capacitor per channel, but also makes the PCB layout easier.

HV7355主要特性:

?? HVCMOS technology for high performance

?? High density integrated ultrasound transmitter

?? 0 to +150V output voltage

?? ±1.5A source and sink current (min.)

?? ±300mA current in CW mode

?? Up to 18MHz operating frequency

?? Matched delay times

?? Built-in gate driver floating voltage regulator

?? 2.5 to 3.3V CMOS logic interface

HV7355應用:

?? Portable medical ultrasound imaging

?? Piezoelectric transducer drivers

?? NDT ultrasound transmission

?? Pulse waveform generator

圖1.HV7355典型應用電路

150V/1.5A單極超聲波脈沖器演示板HV7355DB1

150V, 1.5A, Unipolar Ultrasound Pulser Demoboard

The HV7355 is a monolithic eight-channel, high-speed,high voltage, unipolar ultrasound transmitter pulser. This integrated, high performance circuit is in a single, 8x8x0.9mm, 56-lead QFN package.

The HV7355 can deliver guaranteed ±1.5A source and sink current to a capacitive transducer with 0 to +150V peak voltage. It is designed for medical ultrasound imaging and ultrasound material NDT applications. It can also be used as a high voltage driver for other piezoelectric or capacitive MEMS transducers, or for ATE systems and pulse signal generators as a signal source.

The HV7355’s circuitry consists of controller logic circuits, level translators, gate driving buffers and a high current and high voltage MOSFET output stage. The output stages of each channel are designed to provide peak output currents typically over ±1.5A for pulsing, with up to 150V swings. The upper limit frequency of the pulser waveform is dependent upon the load capacitance. With different capacitance load conditions the maximum output frequency is about 20MHz.

This demoboard datasheet describes how to use the HV7355DB1 to generate the basic high voltage pulse waveform as an ultrasound transmitting pulser.

The HV7355 circuit uses DC-coupling from a 3.3V logic input to output TX0~7 internally, therefore the chip needs three sets of voltage supply rails: VLL (+3.3V), VDD/VSS (+/-5.0V) and VPP (up to +150V). The VPP high voltage supply can be changed rather quickly, compared to the capacitor gatecoupled driving pulsers. This direct coupling topology of the gate drivers not only saves two high voltage capacitors per channel, but also makes the PCB layout easier.

The control signal logic-high voltage should be the same as the VLL voltage of the IC, and the logic-low should be referenced to GND.

The HV7355DB1 output waveforms can be displayed using an oscilloscope by connecting the scope probe to the test points TX0~7 and GND. The soldering jumper can select whether or not to connect the on-board dummy load, a 330pF capacitor paralleling with a 2.5kΩ resistor. The test points can be used to connect the user’s transducer to easily evaluate the pulser.

圖2.演示板HV7355DB1方框圖

圖3.演示板HV7355DB1電路圖

圖4.演示板HV7355DB1外形圖
詳情請見:
http://www.supertex.com/pdf/datasheets/HV7355.pdf

http://www.supertex.com/pdf/misc/HV7355DB1.pdf



本站內容除特別聲明的原創文章之外,轉載內容只為傳遞更多信息,并不代表本網站贊同其觀點。轉載的所有的文章、圖片、音/視頻文件等資料的版權歸版權所有權人所有。本站采用的非本站原創文章及圖片等內容無法一一聯系確認版權者。如涉及作品內容、版權和其它問題,請及時通過電子郵件或電話通知我們,以便迅速采取適當措施,避免給雙方造成不必要的經濟損失。聯系電話:010-82306118;郵箱:aet@chinaaet.com。
主站蜘蛛池模板: 久久99国产综合色| 伊人成影院九九| 美女被免费网站91色| 成年人在线视频网站| 亚洲人成网站色7799| 真实男女动态无遮挡图| 国产大片黄在线观看| 97久久人人超碰国产精品| 成年午夜视频免费观看视频 | 亚洲精品动漫免费二区| 老扒夜夜春宵粗大好爽aa毛片| 国产精品久久久久久久久久影院 | 一级午夜免费视频| 日韩免费a级毛片无码a∨| 亚洲欧美日韩自偷自拍| 精品国产亚洲AV麻豆| 国产免费卡一卡三卡乱码| 131美女爱做免费毛片| 女人把腿给男人桶视频app| 久久久久久久久人体| 欧洲成人在线视频| 亚洲福利一区二区| 精品久久久久久无码中文字幕 | 成人午夜亚洲精品无码网站| 亚州无吗黄瓜视频有直播的不 | 国产精品人成在线播放新网站 | 人妻av无码一区二区三区| 老太脱裤让老头玩ⅹxxxx| 国产日韩精品欧美一区喷水| 91香蕉福利一区二区三区| 好男人www.| 中文字幕久久久| 日本换爱交换乱理伦片| 亚洲av日韩av综合| 欧美日韩国产成人在线观看| 伊人这里只有精品| 精品无人区一区二区三区| 国产乱子伦农村叉叉叉| 黄色免费网址在线观看| 国产精品一区二区av| 91在线|欧美|